Pre-wall installation system for dry build up (plasterboard) AM101/1120 Sádromodul Alca

For dry build up (plasterboard)

Water connection from the back or top via mounting holes: G1/2 ”
Functional range of water pressure: 0,05 – 1,6 MPa
Recommended range of water pressure: 0,3 – 0,5 MPa
Big flush: 6 – 9 l
Small flush: 2,5 – 3,5 l
Factory setting of large flush: 6 l
Factory setting of small flush: 3 l
Hygienic reserve: 3 l
Water volume in the cistern: 9 l
Load test: 400 kg

Application

• For wall-hung WC
• For mounting in front of a support wall or in to a plasterboard construction
• For floor thickness 0–200 mm
• For installation of wall-hung WC pans with a connecting pitch of 180 mm or 230 mm

Features

• Adjustable anchor feet and a spring-lock system, with a range of 0–200 mm
• Visible marks for both leveling and the centerline
• Sliding rail holder for the waste connector can be set to eight positions between 0–93 mm
• Angle valve with the ability to connect to the Mepla piping system
• The frame allows the anchoring to a separate sufficiently strong plasterboard partition, in front of the bearing wall
• The installed module is covered with a plasterboard panel and there is no need for any additional fixing or anchoring elements
• The construction of polystyrene insulation prevents condensation forming on the surface of the tank and dampens the vibrations from the tank into the building structure
• Prepared for connecting a bracket with a DG 1/2” conversion for bidet seats and sprays
• Dual flush independently adjustable with hygienic reserve
• Suitable for installation of remote or sensor flushing
• Compatible with all ALCA flush plates
• Maintenance work without using any tools
• Water supply from the rear/top
• The cistern is made of one piece, thus ensuring 100% impermeability
• The service opening cover simplifies assembly and prevents the penetration of moisture and impurities
• Installation depth adjustable from 20–95 mm
• Installation depth 125 mm
• Frame material: powder-coated metal

Scope of supply

• Cistern with fill and flush valve
• Self-supporting frame
• Fittings 1/2″ water connection with the integrated angle valve Schell 1/2–3/8″
• Fixation set: screw Ø8×60 – 4 pcs, dowel Ø12 – 4 pcs
• Fixation material for fixing the WC pan: threaded rod M12 – 2 pcs, washers – 4 pcs , cover – 2 pcs, nut – 2 pcs, thread protector – 2 pcs
• Elbow waste connector HT 90/90 polyethylene, PE-HD
• Waste reduction HT 90/110 polyethylene, PE-HD
• Inlet seal, PP outlet, wrapping seal
• Drainage seal, PP connector, connector seal
• End-caps set for protecting the connecting holes during installation of the system
• The 2 piece cover of the service opening is simply adjustable
• Set for inserting toilet tablets